dallmeier DVE-4 - Camera Settings; Display Settings

DVE-4 / DVE-8 / DVE-16
www.dallmeier.com 12
Time Server
If the NTP option is activated, the current time can be obtained from a time server.
 Enable the NTP option.
 Enter the IP address of the time server in the Server Address eld.
 Enter the port in the NTP Port eld if required.
 Set in the Interval eld in which time interval (in minutes) the time server has to be
updated.
 Click Save.
Manual Time Setting
IIf no time server is present, the time can be manually set.
 Enable the Manual Time Sync. option.
 Enter in the Set Time eld the required time.
 Enable the Sync with computer time option in order to synchronize the time with the
Device Time if required.
 Activate the Enable DST option (daylight saving time) if required.
 Enter the Start Time and the End Time of the daylight saving time if required.
 Enter the time difference of the daylight saving time in the DST Bias eld if required.
 Click Save.
5.2 Camera Settings
This area allows to make various settings for the connected cameras. It can be congured
among other settings for video streaming, displayed text, motion detection or a sabotage
alarm can be set.
5.2.1 Display Settings
This tab allows to set what is displayed in addition in the camera image and where: camera
name, time and date.
 Open the Display Settings dialog via Remote Conguration > Camera Settings >
Display Settings.