dallmeier DVE-4 - Network Settings; Alarm Settings; Alarm Inputs

DVE-4 / DVE-8 / DVE-16
www.dallmeier.com 25
5.3 Network Settings
The device’s IP address can be changed in the TCP/IP dialog. It can also be congured to
use DHCP (automatic assignment of network settings through a server).
 Open the TCP/IP dialog via Remote Conguration > Network Settings > TCP/IP.
Fig. 5-27
 Select the required NIC Type (network card).
 Enter an appropriate IPv4 Address if required.
 Enter the required IPv4 Subnet Mask.
 Enter the required IPv4 Default Gateway.
 Enter the maximum packet size of the Maximum Transmission Unit in the MTU eld if
required.
 Enter a Preffered DNS Server if required.
 Enter an Alternate DNS Server if required.
 Click Save.
If the network settings are obtained automatically from a server, the checkbox “DHCP”
must be activated. There are no further settings are required.
5.4 Alarm Settings
The alarm inputs and outputs can be congured.
5.4.1 Alarm Inputs
In order to congure an alarm input proceed as follows:
 Open the Alarm Input Settings dialog via Remote Conguration > Alarm Settings >
Alarm Input.