dallmeier DVE-4 - 2 Safety Instructions

DVE-4 / DVE-8 / DVE-16
www.dallmeier.com 5
2 Safety Instructions
Only use the device if it is technically in proper working condition and for the intended pur-
pose while keeping safety and potential dangers in mind.
QualiedPersonnel
The installation, mounting, connection, commissioning and conguration of the device may
only be carried out by qualied personnel.
This also applies to the maintenance, testing and repair, whereat the regulations of the DIN
VDE 0701 series of standards (repair, modication and inspection of electrical appliances)
must be followed.
Regulations
The use of video and audio surveillance systems is, in general, strictly regulated. Inform
yourself about the currently valid laws and regulations regarding data, worker and environ-
mental protection before using the device and ensure compliance with them.
System Components
Only use internal components that have been tested and approved by Dallmeier. Inap-
propriate internal components may cause malfunctions, damages and data loss and may
result in the loss of warranty.
Modications
Do not make any modications to the hardware or software that have not been tested and
approved by Dallmeier.
Inappropriate modications may cause malfunctions, damages and data loss and may
result in the loss of warranty.
Documentation
Read the documents included in the delivery carefully and thoroughly. Always observe the
contained instructions, notes and warnings.
The product documentation contains several documents which are included in the delivery
in printed form and/or on a digital medium.
Store all documents in legible condition in a suitable location in order to provide for later
consultation.
Condensation Water
If the device is brought from a cold to a warm environment, resulting condensation water
may cause malfunctions and damages.
In this case, wait (up to 8 hours) until the device has reached room temperature before
commissioning.
Earthing & Equipotential Bonding
For the safety of persons (protection against dangerous contact voltages) and devices
(protection against over-voltages) and the immunity of information and communication
technology equipment to electromagnetic interferences (EMI), all protective measures,
which are specied by the currently valid DIN, VDE and ISO standards and which provide
for a standard-compliant earthing and a correct equipotential bonding of electrical and elec-
tronic devices, are mandatory and must be fullled by all means.