Danfoss VACON OPTE3

To Next Page

To Previous Page



To get access to the option board slots, remove the screws and open the cover of the control unit.

e30bi040.10

Installing

VACON® RS485 and CAN Bus Option Boards

Installation Guide

Main Page

Table of Contents3
Introduction5
Purpose of this Installation Guide5
Additional Resources5
Manual Version5
Product Overview5
RS485-Based Serial Bus Option Boards5
CAN Bus-Based and Other Option Boards6
VACON® 100 Family Internal RS485 Fieldbus Protocols6
Safety7
Safety Symbols7
Safety Instructions7
Installing8
Installing Option Board in VACON® NXP and NXS8
Installing Option Board in VACON® 100 INDUSTRIAL and FLOW11
Installing Option Board in VACON® 10016
Installing Option Board in VACON19
Installing Option Board in VACON® 20, MI1-MI319
Installing Option Board in VACON® 20, MI4-MI525
Installing Option Board in VACON® 20 X and 20 CP29
Cabling33
General Cabling Instructions for Fieldbus33
Cable Routing33
Strain Relief34
General Cabling Instructions for RS48534
Cable Requirements for CAN Type Option Boards35
Cable Requirements for LON Type Option Boards36
Fieldbus Connectors36
Stripping the Cables37
Grounding the Cable Shield37
RS485-Based Option Boards39
Common Information for the OPTE3/E5 and OPTE2/E8 Option Boards39
The OPTE3/E5 and OPTE2/E8 Option Board Layout39
The Jumpers in the OPTE3/E5 and OPTE2/E8 Option Boards39
The OPTC3/C5 Option Board40
Jumpers in the OPTC3/C5 Option Board41
Cabling and Bus Termination for PROFIBUS Option Boards42
The OPTE2/OPTE8 Option Boards42
Exceptions in Connector Pin Outs42
The Bus Terminal and Bias Resistors43
Setting the Termination Resistance44
The OPTC2/C8 and OPTCJ Option Boards45
Jumpers in the OPTC2/C8, and OPTCJ Option Boards45
CAN Type and Other Fieldbus Option Boards48
The OPTE6 and OPTE7 Option Boards48
The OPTE6 and OPTE7 Option Board Layout48
The Jumpers in the OPTE6 and OPTE7 Option Boards48
The OPTC6 Option Board50
The OPTC6 Option Board Layout50
The Jumpers in the OPTC6 Option Board50
The OPTC7 Option Board51
The OPTC7 Option Board Layout51
The Jumpers in the OPTC7 Option Board52
The OPTC4 Option Board52
The OPTC4 Option Board Layout52
The Jumpers in the OPTC4 Option Board53
The OPTC4 Option Board Topologies53
Troubleshooting55
LED Indications on PROFIBUS Option Boards55
LED Indications on OPTE2/E8 Option Boards56
LED Indications on OPTC2/C8 and OPTCJ Option Boards57
LED Indications on OPTE6 Option Board58
LED Indications on OPTC6 Option Board59
LED Indications on OPTC7 and OPTE7 Option Boards60
LED Indications on OPTC4 Option Board61

Danfoss VACON OPTE3 - Page 17

Table of Contents

Related product manuals