Danfoss vlt aqua Instruction

7.1.3 RS-485 Bus Termination
Use the terminator dip switch on the main control board of the adjustable
frequency drive to terminate the RS-485 bus.
NOTE!
The factory setting for the dip switch is OFF.
Terminator Switch Factory Setting
VLT AQUA Low Harmonic Drive Instruction
Manual
7 RS-485 Installation and Set-up
MG.20.T1.22 - VLT
®
is a registered Danfoss trademark 7-3
7

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled