Danfoss vlt aqua Instruction

Power Connections 4-33
AC line input connections 4-47
Power and Control Wiring for Non-shielded Cables 4-48
Fuses 4-49
Control Cable Routing 4-52
Electrical Installation, Control Terminals 4-54
Connection Examples for Control of Motor with External Signal Provider 4-55
Start/Stop 4-55
Pulse Start/Stop 4-56
Electrical Installation - additional 4-58
Electrical Installation, Control Cables 4-58
Switches S201, S202, and S801 4-60
Final Set-up and Test 4-61
Additional Connections 4-63
Mechanical Brake Control 4-63
Motor Thermal Protection 4-64
5 How to Operate the Low Harmonic Drive 5-1
Ways of Operation 5-1
How to operate the Graphical LCP (GLCP) 5-1
Tips and tricks 5-8
6 How to Program the Low Harmonic Drive 6-1
How to Program the Adjustable Frequency Drive 6-1
How to Program the Active Filter 6-8
Using the Low Harmonic Drive in NPN Mode 6-8
VLT AQUA Drive - Description of Common Parameters 6-9
Main Menu 6-9
Parameter Options
6-48
Default settings 6-48
0-** Operation and Display 6-49
1-** Load / Motor 6-50
2-** Brakes 6-51
3-** Reference / Ramps 6-51
4-** Limits / Warnings 6-52
5-** Digital In / Out 6-53
6-** Analog In / Out 6-54
8-** Communication and Options 6-55
9-** Profibus 6-56
Contents
VLT AQUA Low Harmonic Drive Instruction
Manual
MG.20.T1.22 - VLT
®
is a registered Danfoss trademark

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled