Danfoss vlt aqua - Page 270

Par. No. # Parameter description Default value 4-set-up Change during
operation
Conver-
sion index
Type
10-0* Common Settings 10-00 CAN Protocol null 2 set-ups FALSE - Uint8 10-01 Baud Rate Select null 2 set-ups TRUE - Uint8
10-02 MAC ID SR 2 set-ups TRUE 0 Uint8
10-05 Readout Transmit Error Counter 0 N/A All set-ups TRUE 0 Uint8
10-06 Readout Receive Error Counter 0 N/A All set-ups TRUE 0 Uint8
10-07 Readout Bus Off Counter 0 N/A All set-ups TRUE 0 Uint8
10-1* DeviceNet
10-10 Process Data Type Selection null All set-ups TRUE - Uint8
10-11 Process Data Config Write SR 2 set-ups TRUE - Uint16
10-12 Process Data Config Read SR 2 set-ups TRUE - Uint16
10-13 Warning Parameter 0 N/A All set-ups TRUE 0 Uint16
10-14 Net Reference [0] Off 2 set-ups TRUE - Uint8
10-15 Net Control [0] Off 2 set-ups TRUE - Uint8
10-2* COS Filters 10-20 COS Filter 1 0 N/A All set-ups FALSE 0 Uint16 10-21 COS Filter 2 0 N/A All set-ups FALSE 0 Uint16
10-22 COS Filter 3 0 N/A All set-ups FALSE 0 Uint16
10-23 COS Filter 4 0 N/A All set-ups FALSE 0 Uint16
10-3* Parameter Access
10-30 Array Index 0 N/A 2 set-ups TRUE 0 Uint8
10-31 Store Data Values [0] Off All set-ups TRUE - Uint8
10-32 Devicenet Revision SR All set-ups TRUE 0 Uint16
10-33 Store Always [0] Off 1 set-up TRUE - Uint8
10-34 DeviceNet Product Code 120 N/A 1 set-up TRUE 0 Uint16
10-39 Devicenet F Parameters 0 N/A All set-ups TRUE 0 Uint32
3.1.11. 10-**CAN Fieldbus
3. Parameter Lists VLT
®
AQUA Drive Programming Guide
270 MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
3