Danfoss vlt aqua Programming Guide

2. Parameter Description
2.1. Parameter Selection
Parameters for VLT AQUA Drive FC 202 are grouped into various parameter groups for easy se-
lection of the correct parameters for optimized operation of the frequency converter.
The vast majority of water/ wastewater applications can be programmed using the Quick Menu
button and selecting the parameters under Quick Setup and Function Setups.
Descriptions and default settings of parameters may be found under the section Parameter Lists
at the back of this manual.
0-xx Operation/Display
1-xx Load/Motor
2-xx Brakes
3-xx Reference/Ramps
4-xx Limits/ Warnings
5-xx Digital In/Out
6-xx Analog In/Out
8-xx Comm. and Options
9-xx Profibus
10-xx DeviceNet Fieldbus
11-xx LonWorks
13-xx Smart Logic
14-xx Special Functions
15-xx Drive Information
16-xx Data Readouts
18-xx Info & Readouts
20-xx Drive Closed Loop
21-xx Ext. Closed Loop
22-xx Application Functions
23-xx Time-based functions
25-xx Basic Cascade Controller
26-xx Analog I/O Option MCB 109
27-xx Extended Cascade Controller
29-xx Water Application Functions
31-xx Bypass Option
VLT
®
AQUA Drive Programming Guide 2. Parameter Description
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark 25
2

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled