Danfoss vlt aqua Programming Guide

2.20. Main Menu - Time-based Functions - Group 23
2.20.1. Timed Actions, 23-0*
Use Timed Actions for actions needing to be performed on a daily or weekly basis, e.g. different
references for working hours / non-working hours. Up to 10 Timed Actions can be programmed
in the frequency converter. The Timed Action number is selected from the list when entering
parameter group 23-0* from the Local Control Panel. Par. 23-00 – 23-04 then refer to the selected
Timed Action number. Each Timed Action is divided into an ON time and an OFF time, in which
two different actions may be performed.
NB!
The clock (parameter group 0-7*) must be correctly programmed for Timed Actions
to function correctly.
23-00 ON Time
Array [10]
00:00:0
0
*
[00:00:00 –23:59:59] Sets the ON time for the Timed Action.
NB!
The frequency converter has no back up of the
clock function and the set date/time will reset to
default (2000-01-01 00:00) after a power down
unless a Real Time Clock module with back up is
installed. In par. 0-79,
Clock Fault , it is possible to
program for a Warning in case clock has not been
set properly, e.g. after a power down.
23-01 ON Action
Array [10]
[0] *
DISABLED
[1] No action
[2] Select setup 1
[3] Select setup 2
[4] Select setup 3
[5] Select setup 4
[10] Select preset ref. 0
[11] Select preset ref. 1
[12] Select preset ref. 2
[13] Select preset ref. 3
[14] Select preset ref. 4
[15] Select preset ref. 5
2. Parameter Description VLT
®
AQUA Drive Programming Guide
212 MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
2

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled