Danfoss vlt aqua - Main Menu - Operation and Display - Group

2.2. Main Menu - Operation and Display - Group 0
2.2.1. 0-0* Operation / Display
Parameters related to the fundamental functions of the frequency converter, function of the LCP
buttons and configuration of the LCP display.
2.2.2. 0-0* Basic Settings
Parameter group for basic frequency converter settings.
0-01 Language
Option: Function:
Defines the language to be used in the display.
[0]
*
English
0-02 Motor Speed Unit
Option: Function:
This parameter cannot be adjusted while the motor is running.
The display showing depends on settings in parameter 0-02 and
0-03. The default setting of parameters 0-02 and 0-03 depends
on which region of the world the frequency converter is supplied
to, but can be re-programmed as required.
NB!
Changing the
Motor Speed Unit will reset certain
parameters to their initial value. It is recommen-
ded to select the motor speed unit first, before
modifying other parameters.
[0] *
RPM Selects display of motor speed variables and parameters (i.e.
references, feedbacks and limits) in terms of motor speed
(RPM).
[1] Hz Selects display of motor speed variables and parameters (i.e.
references, feedbacks and limits) in terms of output frequency
to the motor (Hz).
0-03 Regional Settings
Option: Function:
This parameter cannot be adjusted while the motor is running.
The display showing depends on settings in parameter 0-02 and
0-03. The default setting of parameters 0-02 and 0-03 depends
on which region of the world the frequency converter is supplied
to but can be re-programmed as required.
[0]
*
International Sets par. 1-20 Motor Power units to [kW] and the default value
of par. 1-23
Motor Frequency [50 Hz].
2. Parameter Description VLT
®
AQUA Drive Programming Guide
26 MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
2