Danfoss vlt aqua Programming Guide

0 *
[0 - 115] This parameter displays a list of all the frequency converter pa-
rameters deviating from default setting.
9-94 Changed Parameters (5)
Array [116]
No LCP access
Read only
0 *
[0 - 115] This parameter displays a list of all the frequency converter pa-
rameters deviating from default setting.
2.11. Main Menu - CAN Fieldbus - Group 10
2.11.1. 10-** DeviceNet and CAN Fieldbus
Parameter group for DeviceNet CAN fieldbus parameters.
2.11.2. 10-0* Common Settings
Parameter group for configuring common settings for CAN fieldbus options.
10-00 CAN Protocol
Option: Function:
[1]
*
DeviceNet View the active CAN protocol.
NB!
The options depend on installed option.
10-01 Baud Rate Select
Option: Function:
Select the fieldbus transmission speed. The selection must cor-
respond to the transmission speed of the master and the other
fieldbus nodes.
[16] 10 Kbps
[17] 20 Kbps
[18] 50 Kbps
[19] 100 kbps
[20]
*
125 Kbps
[21] 250 Kbps
[22] 500 Kbps
[23] 800 Kbps
VLT
®
AQUA Drive Programming Guide 2. Parameter Description
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark 125
2

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled