Danfoss VLT AutomationDrive FC 300 Series - Control Cables and Terminals; Access to Control Terminals; Control Cable Routing

7.5 Control Cables and Terminals
7.5.1 Access to Control Terminals
All terminals to the control cables are located underneath
the terminal cover on the front of the frequency converter.
Remove the terminal cover by means of a screwdriver (see
illustration).
130BT304.10
Illustration 7.43 Frame sizes A1, A2, A3, B3, B4, C3 and C4
130BT334.10
Illustration 7.44 Frame sizes A5, B1, B2, C1 and C2
7.5.2
Control Cable Routing
Tie down all control wires to the designated control cable
routing as shown in the picture. Remember to connect the
shields in a proper way to ensure optimum electrical
immunity.
Fieldbus connection
Connections are made to the relevant options on the
control card. For details see the relevant fieldbus
instruction. The cable must be placed in the provided path
inside the frequency converter and tied down together
with other control wires (see illustrations).
In the Chassis (IP00) and NEMA 1 units it is also possible to
connect the fieldbus from the top of the unit as shown in
the following pictures. On the NEMA 1 unit a cover plate
must be removed.
Kit number for fieldbus top connection: 176F1742
130BA867.10
Probus Option A
FC300 Service
Illustration 7.45 Inside Location of Fieldbus
130BB255.10
Illustration 7.46 Top Connection for Fieldbus on IP00
Electrical Installation
VLT
®
AutomationDrive FC 300 Design Guide, 0.25-75 kW
136 MG33BE02 - VLT
®
is a registered Danfoss trademark
77
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-21462-Danfoss-131B8966-VLT-Automation-VT-Drive-VFD-FC301-230V-5-HP.aspx