Danfoss VLT AutomationDrive FC 300 Series - Mounting Bracket for Frame Size A5, B1, B2, C1 and C2

When option module A and/or option module B is/are
used, the brim (B) must be fitted to the top cover (A).
NOTE
Side-by-side installation is not possible when using the
IP21/IP4X/TYPE 1 Enclosure Kit
9.13 Mounting Bracket for Frame Size A5,
B1, B2, C1 and C2
Step 1
130BA844.10
Illustration 9.35 Lower Bracket
Position the lower bracket and mount it with screws. Do
not tighten the screws completely since this will make it
difficult to mount the frequency converter.
Step 2
130BA845.10
A
B
Illustration 9.36 Upper Bracket
Measure distance A or B, and position the upper bracket,
but do not tighten it. See dimensions in Table 9.19.
Frame size
IP A [mm] B [mm] Ordering number
A5 55/66 480 495 130B1080
B1 21/55/66 535 550 130B1081
B2 21/55/66 705 720 130B1082
B3 21/55/66 730 745 130B1083
B4 21/55/66 820 835 130B1084
Table 9.19 Details
Options and Accessories
VLT
®
AutomationDrive FC 300 Design Guide, 0.25-75 kW
176 MG33BE02 - VLT
®
is a registered Danfoss trademark
99
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-21462-Danfoss-131B8966-VLT-Automation-VT-Drive-VFD-FC301-230V-5-HP.aspx