Danfoss VLT AutomationDrive FC 300 Series - MCO 305 Programmable Motion Controller

130BA946.10
RemoveJumper to activate Safe Stop
12 13 18 19 27 29 32 33 20
Illustration 9.3 Frame Sizes A2, A3 and B3
DC
DC
130BA945.10
Illustration 9.4 Frame Sizes A5, B1, B2, B4, C1, C2, C3 and C4
If both C0 and C1 options are to be installed, the instal-
lation is carried out as shown in Illustration 9.5. Note that
this is only possible for frame sizes A2, A3 and B3.
RemoveJumper to activate Safe Stop
12 13 18 19 27 29 32 33 20
130BA947.10
Illustration 9.5 Frame Sizes A2, A3 and B3
9.2 MCO 305 Programmable Motion
Controller
NOTE
See the MCO 305 Operating Instructions for more
information.
The VLT Motion Control Option MCO 305 is an integrated
free programmable Motion Controller for VLT Automa-
tionDrive FC 301 and 302. It can be supplied either as an
option card for field installation or as a built-in option. For
retrofit, a mounting kit must be purchased. There is a
different mounting kit for different frames. MCO 305 is to
be used in slot C0 but can be combined with another
option in slot C1.
Mounting kit depending on frame
Order no.
Bookstyle
A2 and A3 (40 mm for one C option) 130B7530
A2 and A3 (60 mm for C0 + C1 option) 130B7531
B3 (40 mm for one C option) 130B1413
B3 (60 mm for C0 + C1 option) 130B1414
Compact
A5 130B7532
B, C, D, E and F (except B3) 130B7533
Table 9.1 Mounting Kit Ordering Numbers
Do not mount the small fan for B4, C3 and C4.
Options and Accessories
VLT
®
AutomationDrive FC 300 Design Guide, 0.25-75 kW
MG33BE02 - VLT
®
is a registered Danfoss trademark 157
9 9
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-21462-Danfoss-131B8966-VLT-Automation-VT-Drive-VFD-FC301-230V-5-HP.aspx