Terminal number Descriptive Name Encoder 1 (Master)
1 +24 V Supply
2 N/A
3 +5V Supply
4 GND
5 A
6 A not
7 B
8 B not
9 Z/Clock
10 Z not/Clock not
11 DATA
12 DATA not
Table 9.3 Terminal Block X56
Terminal number Descriptive Name Digital inputs
1 Digital Input
2 Digital Input
3 Digital Input
4 Digital Input
5 Digital Input
6 Digital Input
7 Digital Input
8 Digital Input
9 Digital Input
10 Digital Input
Table 9.4 Terminal Block X57
Terminal number
Descriptive Name Supply
1 +24 V Supply
2 GND
Table 9.5 Terminal Block X58
Terminal number
Descriptive Name Digital outputs
1 Digital Output/Input
2 Digital Output/Input
3 Digital Output
4 Digital Output
5 Digital Output
6 Digital Output
7 Digital Output
8 Digital Output
Table 9.6 Terminal Block X59
Terminal number
MCO Debug (RS485)
1
CS
Control Select
62 RxD/TxD - P
63 RxD/TxD - N
66 0 V
67 +5 V
Table 9.7 Terminal Block X60
Terminal number MCO CAN Bus
1 N/A
2 CAN - L
3 DRAIN
4 CAN - H
5 N/A
Table 9.8 Terminal Block X62
9.3 General Purpose Input Output Module
MCB 101
MCB 101 is used for extension of digital and analog inputs
and outputs of FC 301 and FC 302.
Contents: MCB 101 must be fitted into slot B in the VLT
®
AutomationDrive.
•
MCB 101 option module
•
Extended fixture for LCP
•
Terminal cover
Illustration 9.10 MCB 101 Option
Options and Accessories
VLT
®
AutomationDrive FC 300 Design Guide, 0.25-75 kW
MG33BE02 - VLT
®
is a registered Danfoss trademark 161
9 9
http://www.RSPSupply.com/p-21462-Danfoss-131B8966-VLT-Automation-VT-Drive-VFD-FC301-230V-5-HP.aspx
To Next Page
Loading...
