Danfoss VLT AutomationDrive FC 300 Series - Page 6

7.8.2 Use of EMC-Correct Cables 146
7.8.3 Earthing of Screened Control Cables 146
7.8.4 RFI Switch 147
7.9 Residual Current Device
147
7.10 Final Setup and Test
147
8 Application Examples
149
8.1.1 Closed Loop Drive System 154
8.1.2 Programming of Torque Limit and Stop 154
9 Options and Accessories
156
9.1.1 Mounting of Option Modules in
Slot A 156
9.1.2 Mounting of Option Modules in
Slot B 156
9.1.3 Mounting of Options in Slot C 156
9.2 MCO 305 Programmable Motion Controller
157
9.3 General Purpose Input Output Module MCB 101
161
9.3.1 Galvanic Isolation in the MCB 101 162
9.4 Encoder Option MCB 102
163
9.5 Resolver Option MCB 103
165
9.6 Relay Option MCB 105
167
9.7 24 V Back-Up Option MCB 107
168
9.8 MCB 112 PTC Thermistor Card
169
9.9 MCB 113 Extended Relay Card
171
9.10 Brake Resistors
172
9.11 LCP Panel Mounting Kit
172
9.12 IP21/IP 4X/ TYPE 1 Enclosure Kit
174
9.13 Mounting Bracket for Frame Size A5, B1, B2, C1 and C2
176
9.14 Sine-wave Filters
177
9.15 Safety Option Module MCB 15x
178
10 RS-485 Installation and Set-up
181
10.1 Installation and Set-up
181
10.1.1 Overview 181
10.2 Network Connection
181
10.3 Bus Termination
181
10.4 RS-485 Installation and Set-up
182
10.4.1 EMC Precautions 182
10.5 Network Configuration
182
10.5.1 Frequency Converter Set-up 182
10.6 FC Protocol Message Framing Structure
182
Contents
VLT
®
AutomationDrive FC 300 Design Guide, 0.25-75 kW
4 MG33BE02 - VLT
®
is a registered Danfoss trademark
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-21462-Danfoss-131B8966-VLT-Automation-VT-Drive-VFD-FC301-230V-5-HP.aspx