Danfoss VLT AutomationDrive FC 360 User Manual

1 Introduction
1.1 Purpose of the Manual
The quick guide provides information for safe installation
and commissioning of the frequency converter.
The quick guide is intended for use by
qualied personnel.
To use the frequency converter safely and professionally,
read and follow the quick guide. Pay particular attention to
the safety instructions and general warnings. Always keep
this quick guide with the frequency converter.
VLT
®
is a registered trademark.
1.2 Additional Resources
Other resources are available to understand advanced
frequency converter functions and programming.
•
The programming guide provides greater detail on
working with parameters.
•
The design guide provides detailed information
about the design and applications of the
frequency converter.
•
Optional equipment is available that may change
some of the procedures described. Be sure to see
the instructions supplied with those options for
specic requirements.
Contact the local Danfoss supplier for technical documen-
tations.
1.3
Document and Software Version
The quick guide is regularly reviewed and updated. All
suggestions for improvement are welcome.
Edition Remarks Software version
MG06A7 Update due to new software release. 1.70
1.4 Approvals and Certications
1.5 Disposal
Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
1.6 Product Overview
A frequency converter is an electronic motor controller
that converts AC mains input into a variable AC waveform
output. The frequency and voltage of the output are
regulated to control the motor speed or torque. The
frequency converter can vary the speed of the motor in
response to system feedback, such as changing
temperature or pressure for controlling fan, compressor, or
pump motors. The frequency converter can also regulate
the motor by responding to remote commands from
external controllers.
In addition, the frequency converter monitors the system
and motor status, issues warnings, or alarms for fault
conditions, starts and stops the motor, optimizes energy
eciency, and oers many more control, monitoring, and
eciency functions. Operation and monitoring functions
are available as status indications to an outside control
system or serial communication network.
Introduction Quick Guide
MG06A702 Danfoss A/S © 03/2017 All rights reserved. 3
1 1

Danfoss VLT AutomationDrive FC 360 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 360
Category	DC Drives
Language	English