3.5.2 Using Screened Control Cables 49
3.5.3 Grounding of Screened Control Cables 50
3.5.4 Control Terminal Types 51
3.5.5 Wiring to Control Terminals 51
3.5.6 Safe Torque Off (STO) 52
3.5.7 Control Terminal Functions 52
3.6 Serial Communication
53
3.7 Optional Equipment
53
3.7.1 Anti-condensation Heater 53
3.7.2 Mains Shield 53
4 Start-up and Functional Testing
54
4.1 Pre-start
54
4.1.1 Safety Inspection 54
4.2 Applying Power
56
4.3 Basic Operational Programming
56
4.3.1 Set-up Wizard 56
4.4 Automatic Motor Adaptation
61
4.5 Check Motor Rotation
61
4.6 Local-control Test
61
4.7 System Start-up
62
5 User Interface
63
5.1 Local Control Panel
63
5.1.1 LCP Layout 63
5.1.2 Setting LCP Display Values 65
5.1.3 Display Menu Keys 65
5.1.4 Navigation Keys 66
5.1.5 Operation Keys 66
5.2 Back-up and Copying Parameter Settings
66
5.2.1 Uploading Data to the LCP 67
5.2.2 Downloading Data from the LCP 67
5.3 Restoring Default Settings
67
5.3.1 Recommended Initialisation 67
5.3.2 Manual Initialisation 67
6 Programming
68
6.1 Introduction
68
6.2 Programming Example
68
6.3 Control Terminal Programming Examples
69
6.4 International/North American Default Parameter Settings
70
Contents Operating Instructions
2 Danfoss A/S © Rev. 05/2014 All rights reserved. MG16J202
To Next Page
Loading...
Need help?
General