6.6 Remote Programming with
MCT 10 Set-up Software
Danfoss has a software program available for developing,
storing, and transferring frequency converter
programming. The MCT 10 Set-up Software allows the user
to connect a PC to the frequency converter and perform
live programming rather than using the LCP. Additionally,
all frequency converter programming can be done off-line
and simply downloaded to the frequency converter. Or the
entire frequency converter profile can be loaded onto the
PC for back-up storage or analysis.
The USB connector or RS-485 terminal are available for
connecting the PC to the frequency converter.
Programming Operating Instructions
76 Danfoss A/S © Rev. 05/2014 All rights reserved. MG16J202
66
To Next Page
Loading...
