Trip An alarm occurred and the motor is stopped.
Once the cause of the alarm is cleared, the
frequency converter can be reset manually by
pressing [Reset] or remotely by control
terminals or serial communication.
Trip lock An alarm occurred and the motor is stopped.
Once the cause of the alarm is cleared, power
must be cycled to the frequency converter.
The frequency converter can then be reset
manually by pressing [Reset] or remotely by
control terminals or serial communication.
Table 8.3 Operation Status
NOTICE
In auto/remote mode, the frequency converter requires
external commands to execute functions.
Status Messages Operating Instructions
MG37A202 Danfoss A/S © Rev. 2014-07-29 All rights reserved. 121
8 8
To Next Page
Loading...
