Danfoss VLT FC 302 User Manual

6.3.1 Parameter Selection
Parameters for the frequency converter are grouped into
various parameter groups for easy selection of the correct
parameters for optimised operation of the frequency
converter.
0-** Operation and display parameters for basic frequency
converter settings
1-** Load and motor parameters, includes all load and
motor related parameters
2-** Brake parameters
3-** References and ramping parameters, includes DigiPot
function
4-** Limits/Warnings, setting of limits and warning
parameters
5-** Digital inputs and outputs, includes relay controls
6-** Analog inputs and outputs
7-** Controllers, setting parameters for speed and process
controls
8-** Communication and option parameters, setting of FC
RS-485 and FC USB port parameters.
9-** Profibus parameters
10-** DeviceNet and CAN Fieldbus parameters
12-** Ethernet parameters
13-** Smart Logic Control parameters
14-** Special Function parameters
15-** Drive Information parameters
16-** Data Readout parameters
17-** Encoder option parameters
18-** Data Readouts 2
30-** Special Features
32-** MCO 305 basic parameters
33-** MCO 305 advanced parameters
34-** MCO data readout parameters
35-** Sensor Input Option
Programming Operating Instructions
MG37A202 Danfoss A/S © Rev. 2014-07-29 All rights reserved. 73
6 6

Danfoss VLT FC 302 Specifications

General

Brake Function	Built-in brake chopper in all units up to 22 kW
Output Voltage Range	0-100% of input voltage
Power Range	0.37 kW
Control Modes	VVCplus, Flux, U/f
Protection Features	Overvoltage, undervoltage, overcurrent, short circuit, overtemperature, overload
Communication Options	Modbus RTU, BACnet, Ethernet/IP, Profinet, Profibus, CANopen, DeviceNet
Ambient Temperature Range	-10°C to +50°C (derating above +40°C)
Enclosure Rating	IP20, IP21, IP55
Cooling Method	Air-cooled
Input Voltage	200-240V, 380-480V, 525-600V