3.4.16 Motor Thermal Protection 30
3.4.17 Control Cable Routing 30
3.4.18 Access to Control Terminals 31
3.4.19 Electrical Installation, Control Terminals 31
3.4.20 Electrical Installation, Control Cables 33
3.4.21 Switches S201, S202, and S801 34
3.4.22 Serial Communication 34
3.5 Final Set-up and Test
34
3.6 Additional Connections
35
3.6.1 Mechanical Brake Control 35
3.6.2 Parallel Connection of Motors 35
3.6.3 F-frame Options 36
4 Start Up and Functional Testing
38
4.1 Pre-start
38
4.2 Applying Power to the Equipment
39
4.3 Basic Operational Programming
39
4.4 Local Control Test
40
4.5 System Start Up
41
5 User Interface
42
5.1 How to Operate
42
5.1.1 Modes of Operation 42
5.1.2 How to Operate Graphical LCP (GLCP) 42
5.1.3 Changing Data 45
5.1.4 Changing a Text Value 46
5.1.5 Changing a Group of Numeric Data Values 46
5.1.6 Changing of Data Value, Step-by-Step 46
5.1.7 Read-out and Programming of Indexed Parameters 46
5.1.8 Quick Transfer of Parameter Settings with the LCP 46
5.1.9 Initialisation to Default Settings 47
5.1.10 RS-485 Bus Connection 47
5.1.11 Connection to a PC 47
5.1.12 PC Software Tools 48
6 Programming
49
6.1 How to Programme the Frequency Converter
49
6.1.1 Quick Setup Parameters 49
6.1.2 Basic Setup Parameters 51
6.2 How to Programme the Active Filter
71
6.2.1 Using the Low Harmonic Drive in NPN Mode 72
Contents Operating Instructions
2 Danfoss A/S © Rev. 2014-07-29 All rights reserved. MG37A202
To Next Page
Loading...
Need help?
General
