Danfoss VLT FC 302

Par. No. # Parameter description Default value 4-set-up FC 302
only
Change
during
operation
Conver-
sion
index
Type
3-8* Other Ramps
3-80 Jog ramp time App.Dependent All set-ups TRUE -2 Uint32
3-81 Quick stop ramp time App.Dependent 2 set-ups TRUE -2 Uint32
3-82 Quick stop ramp type [0] Linear All set-ups TRUE - Uint8
3-83 Quick stop S-ramp ratio at decel. start 50 % All set-ups TRUE 0 Uint8
3-84 Quick stop S-ramp ratio at decel. end 50 % All set-ups TRUE 0 Uint8
3-9* Digital Pot.Meter
3-90 Step size 0.10 % All set-ups TRUE -2 Uint16
3-91 Ramp time 1.00 s All set-ups TRUE -2 Uint32
3-92 Power restore [0] Off All set-ups TRUE - Uint8
3-93 Maximum limit 100 % All set-ups TRUE 0 Int16
3-94 Minimum limit -100 % All set-ups TRUE 0 Int16
3-95 Ramp delay App.Dependent All set-ups TRUE -3 TimD
Programming Operating Instructions
MG37A202 Danfoss A/S © Rev. 2014-07-29 All rights reserved. 79
6 6