Danfoss VLT FC Series Service Guide

1.4 Conventions
•
Numbered lists indicate procedures.
•
Bulleted lists indicate other information.
•
Italicized text indicates the following:
- Cross-reference
- Link
- Parameter name
- Parameter option
- Parameter group name
•
All dimensions in drawings are in mm (inch).
•
An asterisk (*) indicates default setting of a
parameter.
1.5 Document Version
This guide is regularly reviewed and updated. All
suggestions for improvement are welcome. Table 1.2 shows
the document version and comments about changes made
to the edition.
Edition Remarks
MG94A5xx Updated procedures and
illustrations for D1h–D8h drives.
Added content for J8–J9 drives,
D9h–D10h/E5h–E6h drive modules,
and data for 200–240 V (T2) drives.
Table 1.2 Document Version
1.6
Approvals and Certications
The following list is a selection of possible type approvals
and certications for Danfoss drives:
089
NOTICE
The specic approvals and certication for the drive can
be found on the nameplate. For more information,
contact the local Danfoss oce or partner.
For more information on UL 508C thermal memory
retention requirements, refer to the section Motor Thermal
Protection in the product-specic design guide.
For more information on compliance with the European
Agreement concerning International Carriage of Dangerous
Goods by Inland Waterways (ADN), refer to section ADN-
compliant Installation in the product-specic design guide.
1.7
Disposal
Do not dispose of equipment containing
electrical components together with
domestic waste.
Collect it separately in accordance with
local and currently valid legislation.
Introduction Service Guide
MG94A502 Danfoss A/S © 02/2019 All rights reserved. 11
1 1

Danfoss VLT FC Series Specifications

General

Brand	Danfoss
Model	VLT FC Series
Category	DC Drives
Language	English