Danfoss VLT Micro Drive FC 51 Programming Guide

5.1.5 0-** Operation/Display
Parameter
Number
Parameter Description Default Value 2 Setup
Change During
Operation
Conversi
on
Index
Type
0-03 Regional Settings [0] International 1 set-up FALSE - Uint8
0-04
Operating State at Power-up
(Hand) [1] Forced stop ref=old All set-ups TRUE - Uint8
0-10 Active Set-up [1] Set-up 1 1 set-up TRUE - Uint8
0-11 Edit Set-up [1] Set-up 1 1 set-up TRUE - Uint8
0-12 Link Setups [20] Linked All set-ups FALSE - Uint8
0-31 Custom Readout Min Scale 0 1 set-up TRUE -2 Int32
0-32 Custom Readout Max Scale 0 1 set-up TRUE -2 Int32
0-40 [Hand On] Key on LCP [1] Enabled All set-ups TRUE - Uint8
0-41 [Off / Reset] Key on LCP [1] Enable All All set-ups TRUE - Uint8
0-42 [Auto on] Key on LCP [1] Enabled All set-ups TRUE - Uint8
0-50 LCP Copy [0] No copy 1 set-up FALSE - Uint8
0-51 Set-up Copy [0] No copy 1 set-up FALSE - Uint8
0-60 Main Menu Password 0 1 set-up TRUE 0 Uint16
0-61
Access to Main/Quick menu w/o
Password 0 1 set-up TRUE - Uint8
Table 5.8
Parameter Lists
VLT
®
Micro Drive FC 51 Programming Guide
MG02C602 - VLT
®
is a registered Danfoss trademark
55
5 5
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-12769-Danfoss-132F0026-VFD-Micro-Drive-440V-5HP.aspx

Danfoss VLT Micro Drive FC 51 Specifications

General

Enclosure	IP20
Output Voltage	0-100% of supply voltage
Altitude	Up to 1000 m without derating
Power Range	0.18-22 kW
Control Method	V/f
Communication	Modbus RTU
Protection Features	Over-voltage, under-voltage, over-current, over-temperature
Ambient Temperature	-10°C to 50°C
Storage Temperature	-25°C to 65°C
Relative Humidity	5-95% (non-condensing)
Input Voltage	200-240 V, 380-480 V
Braking Function	Integrated braking chopper (optional)