4.12 Parameter Group 15: Drive Information
Parameter group containing information on operating
data,
hardware configuration, software version, etc.
15-00 Operating Time
Range: Function:
0 days* [0-65535
days]
View how many days the frequency
converter
has been powered up.
The value is saved at power off and
cannot be reset.
15-01 Running Hours
Range: Function:
0* [0- 2147483647] View running hours of motor.
The value is saved at power off and can be
reset in 15-07 Reset Running Hours Counter.
15-02 kWh Counter
Range: Function:
0 [0-65535] View power consumption in kWh as a mean value
over
one hour.
Reset counter in 15-06 Reset kWh Counter.
15-03 Power Ups
Range: Function:
0 [0-2147483647] View number of times frequency converter
has
been powered up.
Counter cannot be reset.
15-04 Over Temps
Range: Function:
0 [0-65535] View number of times frequency converter has
tripped
due to over temperature.
Counter cannot be reset.
15-05 Over Volts
Range: Function:
0* [0-65535] View number of times frequency converter has
tripped
due to over voltage.
Counter cannot be reset.
15-06 Reset kWh Counter
Option: Function:
[0] * Do Not Reset Counter is not reset.
[1] Reset Counter Counter is reset.
15-07 Reset Running Hours Counter
Option: Function:
[0] * Do Not Reset Counter is not reset.
[1] Reset Counter Counter is reset.
4.12.1 15-3* Fault Log
This parameter group contains a fault log showing reasons
for
the ten latest trips.
15-30 Fault Log: Error Code
Range: Function:
0 [0-255]
View error code and look it up in VLT
Micro Quick
Guide, MG02B.
4.12.2 15-4* Drive Identification
Parameters containing read only information about the
hardware
and software configuration of the frequency
converter.
15-40 FC Type
Option: Function:
View FC type.
15-41 Power Section
Option: Function:
View power section of frequency converter.
15-42 Voltage
Option: Function:
View voltage of frequency converter.
15-43 Software Version
Option: Function:
View software version of frequency converter.
15-46 Frequency Converter Ordering No
Option: Function:
View ordering number for re-ordering frequency
converter
in its original configuration.
15-48 LCP ID No
Option: Function:
View LCP ID number.
15-51 Frequency Converter Serial Number
Option: Function:
View frequency converter serial number.
Parameter Descriptions
VLT
®
Micro Drive FC 51 Programming Guide
MG02C602 - VLT
®
is a registered Danfoss trademark
47
4 4
To Next Page
Loading...
