Danfoss VLT Micro Drive FC 51 User Manual

7 Specications
7.1 Mains Supply 1x200–240 V AC
Table 12: Mains Supply 1x200–240 V AC
Normal overload 150% for 1 minute
Drive
PK18
PK37
PK75
P1K5
P2K2
Typical shaft output [kW]
0.18
0.37
0.75
1.5
2.2
Typical shaft output [hp]
0.25
0.5
1
2
3
Enclosure protection rating IP20
M1
M1
M1
M2
M3
Output current
Continuous (3x200–240 V AC) [A]
1.2
2.2
4.2
6.8
9.6
Intermittent (3x200–240 V AC) [A]
1.8
3.3
6.3
10.2
14.4
Maximum cable size
(Mains, motor) [mm
2
/AWG]
4/10
Maximum input current
Continuous (1x200–240 V) [A]
3.3
6.1
11.6
18.7
26.4
Intermittent (1x200–240 V) [A]
4.5
8.3
15.6
26.4
37
Maximum mains fuses [A]
See chapter Fuses.
Environment
Estimated power loss [W],
Best case/typical
(1)
12.5/
15.5
20/
25
36.5/
44
61/
67
81/
85.1
Weight enclosure IP20 [kg]
1.0
1.0
1.0
1.5
2.8
Eciency [%],
Best case/typical
(2)
95.6/
94.5
96.5/
95.6
96.6/
96
97/
96.7
96.9/
97.1
1
Applies for dimensioning of drive cooling. If the switching frequency is higher than the default setting, the power losses may increase. LCP and
typical control card power consumptions are included. For power loss data according to EN 50598-2, refer to Danfoss
MyDrive® ecoSmartTM website.
2
Eciency measured at nominal current. For energy eciency class, see chapter Surroundings. For part load losses, see DanfossMyDrive® ecoS-
martTM website.
7.2 Mains Supply 3x380–480 V AC
Table 13: Mains Supply 3x380–480 V AC
Normal overload 150% for 1 minute
Drive
PK37
PK75
P1K5
P2K2
P3K0
P4K0
Typical shaft output [kW]
0.37
0.75
1.5
2.2
3.0
4.0
Typical shaft output [hp]
0.5
1
2
3
4
5.5
Enclosure protection rating IP20
M1
M1
M1/M2
M2
M3
M3
Output current
AQ348848915086en-000101 / 130R094326 | Danfoss A/S © 2020.09
Specications
VLT® Micro Drive FC 51
Operating Guide

Danfoss VLT Micro Drive FC 51 Specifications

General

Brand	Danfoss
Model	VLT Micro Drive FC 51
Category	DC Drives
Language	English