VLT
®
2800 Series
All about VLT
2800
PNU
#
Parameter
description
Factory setting 4-setup Conv.
index
Data
type
600 Ope rating hours No 73 7
601 Hou rs run No 73 7
602 kWh counter No 2 7
603 Number of cut ins No 0 6
604 Number of overtemperatures No 0 6
605 Num ber of ov e rvoltages No 0 6
615 Fault log: Error code No 0 5
616 Fault log: Time No 0 7
617 Fault log: Value No 0 3
618 Reset of kWh c ou nter No reset No 0 7
619 Reset of running hours counter No reset No 0 5
620 Operation mode Normal operation No 0 5
621 Nameplate: Unit type No 0 9
624 Nameplate: Software version No 0 9
625 Nameplate: LCP identification no. No 0 9
626 Nameplate: Database identification no. No -2 9
627 Nam eplate: Power parts v ersion No 0 9
628 Nameplate: Application option type No 0 9
630 Nam eplate: Communication option type N o 0 9
632 Nameplate: BM C software identification No 0 9
634 Nameplate: Unit identification for com m unica t ion No 0 9
635 Namep late: Software parts no . No 0 9
640 Software version No -2 6
641 BMC software identificat io n No -2 6
642 Power card identification No -2 6
4-Setup:
’Yes’ means that the parameter can be programmed
individually in each of the fo u r Setups, i.e. one single
parameter can have four different data value s. No’
means that the data value will be the same in all Setups.
C
onversion index:
This number refers to a conversion figure to be used
when writing or reading via serial communication
with a frequency converter.
See Data ch aracter in Serial communication
in the Design Guide.
D
ata type:
Data type shows the type and length of the telegram.
Data type Description
3 Integer 16
4 Integer 32
5 Unsigned 8
6 Unsigned 1 6
7 Unsigned 3 2
9Textstring
MG.28.E9.02 - VLT is a registered Danfoss trademark
159
To Next Page
Loading...
Need help?
General
