CE870 Instant Issuance System User’s Guide 23
Press the U
SER button to suspend the printer. Then, press ENTER to enter the menu system. Use
the arrow keys to move through the menus, and press E
NTER to make a selection. The menu
system has four major branches:
Use the Maintenance menu to run a cleaning card, print a test card, or reset the locks on the
system.
Use the Status menu to see settings and data about the printer.
Use the Configuration menu to change printer settings.
Use the Activate menu to enable and disable secure features of the printer. This menu is used
only during installation or removal of a financial system that requires activation.
HINTS & TIPS
You can access the menu system when the system is not actively processing cards and Ready
displays on line 1 of the LCD panel.
The printer returns to the Ready status after two minutes of no activity. Changes that have
not been applied are lost.
To leave a selection without changing the value, press the up or down arrow key until Exit
displays, and then press E
NTER.
You can use the LCD menu to view or change several printer settings, including the following:
Pause the System on page 24
View the Printer Serial Number from the LCD Menu on page 25
Retrieve the Printer’s Network IP Address on page26
View Card Counts from the LCD Menu on page 28
Change the LCD Backlight Brightness on page 30
Set Magnetic Stripe Coercivity from the LCD Menu on page 31
To Next Page
Loading...
Need help?
General
