EasyManua.ls Logo

DataCard CE870

DataCard CE870
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CE870 Instant Issuance System User’s Guide 39
Load Cards in the Input Hopper
 Cards can stick together. Slide or fan the cards to separate the edges before placing them in
the input hopper. Handle cards by their edges only, or wear gloves.
 Insert ISO magnetic stripe cards with the stripe (back side) facing down and to the right.
 Insert smart cards with the smart card chip facing up and toward the back of the hopper.
Single Hopper System
1. Unlock the printer and open the hopper.
2. Load the cards into the input hopper. The input hopper
can hold up to 100 cards.
3. Close the input hopper and lock the printer when you
finish loading cards.
Multi-Hopper System
1. Unlock the printer and open the multi-
hopper.
2. Load the cards into the hoppers.
The input hoppers are labeled H1 through
H6. Each input hopper can hold up to 100
cards.
3. Close the multi-hopper and lock the printer
when you finish loading cards.
A diagram inside the input hopper shows the correct orientation for each type of card.

Table of Contents

Other manuals for DataCard CE870

Related product manuals