DataCard CE870

78 Troubleshooting
135: Indent ribbon supplies out
The embosser does not have usable indent ribbon.
1. Open the embosser and remove the indent ribbon cartridge.
2. Install a new indent ribbon.
3. Replace the cartridge, and then close and lock the embosser.
HINTS & TIPS
Refer to “Load the Indent Ribbon Cartridge” on page 33 for more information.
136: Indent ribbon break
The embosser indent ribbon is not moving properly.
1. Open the embosser and remove the indent ribbon cartridge.
2. Reposition, repair, or replace the ribbon and advance the repaired area one full turn.
3. Replace the cartridge, and then close and lock the embosser.
HINTS & TIPS
Refer to “Load the Indent Ribbon Cartridge” on page 33 or “Repair Broken Indent Ribbon or
Topping Foil” on page 62.
137: Embosser wheel error
The card path is blocked in the embosser.
1. Open the embosser and remove the supply cartridges.
2. Remove any cards found.
3. Replace the cartridges, and then close and lock the embosser.
138: Embosser indent error
The embosser indent ribbon is not moving properly.
1. Open the embosser and remove the indent ribbon cartridge.
2. Reposition, repair, or replace the ribbon and advance the repaired area one full turn.
3. Replace the cartridge, and then close and lock the embosser.