DataCard CE870

CE870 Instant Issuance System User’s Guide 31
Set Magnetic Stripe Coercivity from the LCD Menu
The setting for coercivity can be changed from the LCD panel, if needed. Usually, coercivity is a
system-wide decision and does not change.
1. Enter the menu system.
a. Press the U
SER button.
Suspended displays on line 1 of the LCD panel.
b. Press E
NTER to enter the menu system.
c. Press the down arrow key until Configuration displays on
line 2 of the LCD panel.
d. Press E
NTER to enter the Configuration menu.
2. Set Magnetic Stripe Coercivity.
a. Press the down arrow key until Magstripe displays on
line 2 of the LCD panel.
b. Press E
NTER to enter the Magstripe menu.
c. Press the down arrow key until Coercivity displays on line 2
of the LCD panel.
d. Press E
NTER to enter the Coercivity menu.
i. Press an arrow key to display the intended coercivity.
ii. Press E
NTER. Apply displays on line 2 of the LCD panel.
iii. Press E
NTER to save the value.
iv. The printer saves the value and returns to the
Magstripe menu.
Press E
NTER to exit the Magstripe menu.