DataCard SD160 User Manual

XPS Card Printer Driver User’s Guide 5
Chapter 2: XPS Card Printer
Driver Installation
This chapter provides information about how to install the Card Printer
Driver.
Before You Install
The Card Printer Driver typically is installed using the installation CD shipped with the printer. You
also can install it using a downloaded installation file.
Be aware of the following as you plan to install the Card Printer Driver.
 Prepare the printer before installing the Card Printer Driver. Load the printer supplies and
cards as described in your printer’s Quick Install Guide or Installation and Administrator’s
Guide.
 The Card Printer Driver installation assigns a default printer name. Each printer must have a
different name. The installation automatically creates a unique name.
If your site plans to implement printer sharing, have a printer naming plan in place before
installing the Card Printer Driver. You cannot rename a printer after sharing is enabled. Refer
to “Use Printer Sharing” on page 28 for more information.
Installation Overview
Basic installation includes the following steps:
1. Identify Your Installation Requirements on page 6.
2. Prepare to Install the Card Printer Driver on page 7.
3. Install the driver based on the printer/PC communication method you are using, either USB
or a network connection. Refer to “Install the Driver” on page 9.
4. Update your existing driver installation if your driver version is 4.0 or newer. Refer to “Update
the Card Printer Driver” on page 17.

DataCard SD160 Specifications

General

Print Technology	Dye Sublimation
Print Resolution	300 dpi
Connectivity	USB 2.0
Power Requirements	100-240 VAC, 50/60 Hz
Card Capacity	100 cards input hopper, 25 cards output hopper
Card Size	CR80 (85.6 mm x 54 mm)
Operating System Support	Windows 7, Windows 8, Windows 10
Card Thickness	0.020" to 0.030" (0.51 mm to 0.76 mm)
Print Speed	Up to 150 cards per hour (YMCKT)