Datakom DK-40 - Page 26

DK-40 USER MANUAL V2.6 (02.08.2011)
K13D01-E - 26 -
No Description Adjustment Range Factory set
P27
Unload timer fixed or
variable
0: Fixed
1: Variable
If set to 1:
If the stop duration is more than
the unload run duration, the
unload timer is reduced by 1
minute at each run, until an
absolute minimum of 2 minutes.
0
P28 Safety Timer
1 ... 240
Refer to chapter 4 for this
parameter.
30 sec
P29 Service A Period
0 ... 32767
If this parameter is set to 0, then
no service A warning is given.
2000 hours
P30 Service B Period
0 ... 32767
If this parameter is set to 0, then
no service B warning is given.
4000 hours
P31 Service C Period
0 ... 32767
If this parameter is set to 0, then
no service C warning is given.
6000 hours
P32 Service D Period
0 ... 32767
If this parameter is set to 0, then
no service D warning is given.
14000 hours
P33 Service E Period
0 ... 32767
If this parameter is set to 0, then
no service E warning is given.
20000 hours
P34 Display Extra sensors
0: Disable
1: Enable
1
P35 Low level password 0 ... 999 386
P36 High level password 0 ... 999 741
P37 Maximum Starts per Hour 6 ... 60 20
P38 Low Voltage Alarm Enable
0:Disable
1:Enable
If this parameter is set to 0, the
P39 parameter will not be
displayed.
1
P39 Low Voltage Alarm Value 200 ... 600 360 V-AC