Datalogic Falcon X3 User Manual

BATTERIES AND MAINTENANCE
2
2.2 REPLACING THE BATTERY PACK
To correctly replace the battery pack, proceed as follows.
1. Turn off the Falcon X3™.
2. Press the latch release and lift battery from the enclosure as indicated in
the figure below:
3. Install the new battery pack, first insert the top end, then the latch bottom
as indicated in the following figure.
11

Datalogic Falcon X3 Specifications

General

RAM	256 MB
Flash Memory	1 GB
IP Rating	IP65
Operating System	Windows Embedded Handheld 6.5
Expansion Slot	MicroSD
Drop Resistance	1.8 m / 6.0 ft drops to concrete
Humidity	5 to 95% (non-condensing)
Supported Symbologies	PDF417, Data Matrix, QR Code
Operating Temperature	-10°C to 50°C (14°F to 122°F)