Datalogic Magellan 1500i - Error Codes

16 Magellan™ 1500i
Error Codes
If an error is detected, the scanner will sound a long low tone (for
three seconds) and flash its LED, indicating a failure. When this
occurs, press the Scanner button to hear the error code. If it is
configured to do so, the scanner will sound a series of beeps cor-
responding to the error code and/or flash its LED simultaneous
to the beeps. The table below describes what these codes mean
and what action should be taken for each.
NUMBER OF
LED FLASHES/
BEEPS
ERROR CORRECTIVE ACTION
1 Configuration
Contact Helpdesk for assis-
tance
2
Host Interface
6 Main PCB
10 Button Error
11 USB Device
13 FPGA ID