Datalogic Magellan 1500i - Manufacturer Approved Cleaning Materials

18 Magellan™ 1500i
Manufacturer Approved Cleaning Materials
Datalogic recommends the use of the following cleaners on its
products.
Under no circumstances should abrasive cleansers, abrasive
pads, caustic solutions or other harsh chemicals, including those
listed below, be used on any part of the scanner as they can
cause damage which will adversely affect scanning performance.
Use of such materials, either alone or in combination with other
cleaning agents, will void the manufacturer's warranty.
APPROVED CLEANERS
•Hydrogen Peroxide (not to exceed a 3% solution)
•Chlorine bleach (not to exceed a 0.25% solution)
•Mild detergent and water
•lsopropyl Alcohol (not to exceed a 70% solution)
CAUTION
Use of above cleaners in combination with each other is
not recommended and may constitute a health hazard.
Follow all specified safety precautions when using any
cleaning solution.
!!DO NOT USE!!
•Ammonia solutions •Trichloroethylene
•Acetone •Toluene
•Benzene •Carbolic acid
•Ethanolamine •Aromatic or chlorinated hydrocarbons
•Ethers •Aqueous or alcoholic alkaline solutions
•Ketones