Programming
5-180 Magellan
TM
2200VS and 2300HS
RSS-14 2D Component Enable
When this feature is enabled, the software will not decode an RSS-14 bar
code with a 2D component associated with it, and the 2D component will
be discarded.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan your selection from the bar codes below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
RSS-14 2D COMPONENT = DISABLE
RSS-14 2D COMPONENT = ENABLE
To Next Page
Loading...
Need help?
General
