General Scanner Features
Product Reference Guide 5-27
Good Read Beep Volume
Selects the beeper volume upon a good read beep. There are four select-
able volumes, with each volume incrementing upward from the previous
decibel level:
•0 = Lowest Volume
•1 = Medium-Low Volume
•2 = Medium Volume
•3 = High Volume
To set the Good Read Beep Volume:
1. Scan the SWITCH bar code.
2. Scan your selected volume bar code from this or the following pages.
You’ll need to cover any unused bar codes on this and the facing
page to ensure that the scanner reads only the bar code you intend
to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
GOOD READ BEEP VOLUME = LOWEST
To Next Page
Loading...
Need help?
General
