Enter/Exit Programming Mode
Product Reference Guide
231
Time Tx Format
Sets the format of the time.
DEFAULT
hh:mm:ss (ISO 8601)
hhmmss (No ISO)
Date-Time Separator
Sets the character used to separate Date and Time from the next field in
message.
DEFAULT
Disable Date-Time Separator
Set Character Separator
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 2 digits from the Alphanu-
meric characters in
Appendix D, Keypad
repre-
senting your desired character(s). End by scanning
the ENTER
/EXIT bar code twice.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
CANCEL
To Next Page
Loading...
