Datalogic PowerScan PD9130 - Set F3 Label; Set F4 Label

Enter/Exit Programming Mode
Product Reference Guide 281
Set F3 Label
This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
th
e Function Key below it.
Set F3 label
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at left
fol
lowed by 8 digits from the
Appendix D, Keypad . The
digits must be the hexadecimal ASCII representation of the
de
sired characters.
End by scanning the ENTER/EXIT bar code twice.
Set F4 Label
This item allows the user to change the default mnemonic label associated
to each individual function key. This is done by programming a short acro-
nym 4-character string to be shown in the bottom of the display. The pur-
pose of the label is to serve as an indication of the programmed function of
th
e Function Key below it.
Set F4 label
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at left
fol
lowed by 8 digits from the
Appendix D, Keypad . The
digits must be the hexadecimal ASCII representation of the
de
sired characters.
End by scanning the ENTER/EXIT bar code twice.