Datalogic PowerScan PD953X User Manual

Enter/Exit Programming Mode 2D Global Features
196 PowerScan™ PD953X/PBT950X/PM950X
QR Code Set Length 1
Specifies one of the bar code lengths for QR Code Length Control. Length 1
is the minimum label length if in Va
riable Length Mode, or the first fixed
length if in Fixed Length Mode. Characters can be set from 0001 to 7,089
characters in increments of 0001 (pad with zeroes).
See page 281 for detailed instructions on setting this feature.
Select QR Code Length 1 Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scanning
the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
0001 = Length 1 is 1 Character
QR Code Set Length 2
This feature specifies one of the bar code lengths for QR Code Length Con-
trol. Length 2 is the maximum label length if in Variable Length Mode, or the
second fixed length if in Fixed Length Mode. Charact
ers can be set from
0001 to 7,089 characters in increments of 0001 (pad with zeroes).
See page 282 for detailed instructions on setting this feature.
$CQRL2
Select QR Code Length 2 Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scanning
the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL
bar code to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
DEFAULT
Length 2 is 7,089 Characters

Datalogic PowerScan PD953X Specifications

General

Brand	Datalogic
Model	PowerScan PD953X
Category	Barcode Reader
Language	English