Datalogic PowerScan PD953X

Enter/Exit Programming Mode
Product Reference Guide 267
Set Key Sequence ID
Sets the identifier for keyboard composed strings.
$CPWEC
Set keys sequence ID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left fo
llowed by 6 digits from
Appendix D, Keypad .
The ID characters must be represented by their hexa-
decimal ASCII code; if the first 2 digits are 0, this feature
i
s disabled. End by scanning the ENTER/EXIT bar code
again.
Set Key Sequence Header
Sets the header for keyboard composed strings.
$CPWE1
Set key sequence header
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 32 digits from the Alphanu-
meric characters in
Appendix D, Keypad . The
digits must be the hexadecimal ASCII representation
of t
he desired characters.
If less than the expected string of 16 characters are
selected,
scan the ENTER/EXIT bar code to termi-
nate the string.
If the first 2 digits are 0, the
feature is disabled. End
by scanning the ENTER/EXIT bar code again.
Set Key Sequence Terminator
Sets the terminator for keyboard composed strings.
$CPWE2
Set key sequence terminator
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by 32 digits from the Alphanu-
meric characters in
Appendix D, Keypad . The
digits must be the hexadecimal ASCII representation
of t
he desired characters.
If less than the expected string of 16 characters are
selected,
scan the ENTER/EXIT bar code to termi-
nate the string.
If the first 2 digits are 0, the
feature is disabled. End
by scanning the ENTER/EXIT bar code again.