Datalogic PowerScan PD953X - Arrow up String (4-Key Models Only); Arrow down String (4-Key Models Only)

Enter/Exit Programming Mode
250 PowerScan™ PD953X/PBT950X/PM950X
Arrow Up String (4-key models only)
Associate a pre-defined string to the Arrow Up key
$CDAUS
Set string for Arrow Up Key
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left.
Define the label string by further scan-
ning 32 digits from the Alphanumeric characters
in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII represen-
tation of the desired characters; if less than the
e
xpected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
an
d not save the entry string. You can then start
again at the beginning.
~
CANCEL
Arrow Down String (4-key models only)
Associate a pre-defined string to the Arrow Down key
$CDADS
Set string for Arrow Down Key
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left. Define the label string by further scan-
ning 32 digits from the Alphanumeric characters in
Appendix D, Keypad .
The digits must be the hexadecimal ASCII represen-
tation of the desired characters; if less than the
e
xpected string of 16 characters are selected, scan
the ENTER/EXIT bar code to terminate the string.
End by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
an
d not save the entry string. You can then start
again at the beginning.
~
CANCEL