Datalogic PowerScan PD953X

Enter/Exit Programming Mode
Product Reference Guide 247
Display Contrast
Adjust the contrast of the display.
$CDICT
Set Display Contrast
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by two digits (00-32 by 01) from
the Alphanumeric characters in
Appendix D,
Keypad representing your desired character(s). End
by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
~
CANCEL
Font Size
Select the font size.
DEFAULT
$CDIFS00\r
Font Size = Small
$CDIFS01\r
Font Size = Medium
$CDIFS02\r
Font Size = Large