Datamax E-Class Mark II User Manual

Chapter 3 – Printer Operation 25
3
3
3
.
.
.
8
8
8
I
I
I
n
n
n
t
t
t
e
e
e
r
r
r
n
n
n
a
a
a
l
l
l
L
L
L
a
a
a
b
b
b
e
e
e
l
l
l
s
s
s
The following section details the resident information and test labels.
3.8.1 Database Configuration Label
The Database Configuration Label provides information
including the printer firmware version, memory allocations,
enabled options, and label-counter data.
Print a Database Configuration Label as follows:
1) Load with media (4 inch wide) and ribbon (if printing
with thermal transfer media).
2) Turn the printer on. Both LEDs will be on.
3) When the right LED turns off, press and hold the
button until the Database Configuration Label begins to
print.
(Printed label may not match the label shown above.)

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz