24 Chapter 3 – Printer Operation
7) The Calibration Wizard will now prompt you to
Load Backing. Peel off a few labels and
position the backing material over the media
sensor. Close the cover and click OK.
6) The Calibration Wizard will now prompt you to
Load Stock. Ensure that media is properly
loaded in the printer then close the cover and
click OK.
9) The Calibration Wizard will now respond with
Passed Calibration and green light on the
printer; click OK. Each press of the
button
should advance one label.
If the calibration was unsuccessful, retry the
procedure beginning at Step 5.
To Next Page
Loading...
