Datamax Mark II M-4206 User Manual

iv
5.3.6 User Defined Label ............................................ 67
5.4 Media Sensor Calibration ............................................. 68
5.4.1 Quick Calibration................................................ 68
5.4.2 Standard Calibration .......................................... 69
5.4.3 Advanced Entry Calibration................................ 72
Maintenance and Adjustments
6.0 Introduction................................................................... 79
6.1 Cleaning the Printhead................................................. 80
6.1.1 Automated Printhead Cleaning .......................... 81
6.2 Media Width Adjustment............................................... 82
6.3 Printhead Burn Line Adjustment................................... 83
6.4 Printhead Pressure Adjustment.................................... 84
6.5 Printhead Replacement................................................ 85
6.6 Darkness Adjustment ................................................... 86
6.7 Resetting the Printer..................................................... 86
6.8 Downloading Firmware and Fonts................................ 88
Troubleshooting
7.0 Problem Resolution ...................................................... 89
7.1 Fault and Warning Messages....................................... 93
7.2 Hex Dump Mode........................................................... 98
Specifications............................................................... 99

Datamax Mark II M-4206 Specifications

General

Print Resolution	203 dpi
Type	Label Printer
Print Method	Thermal Transfer
Max Print Speed	6 inches per second
Memory	16 MB SDRAM, 8 MB Flash
Interfaces	USB, Serial, Parallel
Media Width	4.5 inches
Media Length	0.25" to 99"
Max Print Width	4.25 inches (108 mm)