40 W-Class
System Settings (continued)
BACK AFTER PRINT
When the present distance is set with the
cutter, present sensor or GPIO option
enabled, this setting determines the timing
of the label back up.
ENABLED
Commands the printer to immediately back
up the label after the cut operation, the
GPIO start of print signal is received, or the
present sensor is clear. It provides the
advantage of faster throughput.
DISABLED
The printer will not initiate repositioning
until the next label is ready to print. May
help prevent the curling of the label edge.
MENU LANGUAGE ♦
Selects the language in which the menu
system messages and configuration label
are shown. Only languages that are resident
will be available.
ENGLISH
English
FRENCH
French
ITALIAN
Italian
GERMAN
German
SPANISH
Spanish
USER DEFINED
User defined, downloaded language(s).
To Next Page
Loading...
