58 W-Class
Standard Calibration (continued)
Step Operator Action Displayed Message Comment
9
Observe the display.
GAP MODE
CALIBRATION COMPLETE
Or, for reflective media:
REFLECTI VE MOD E
CALIBRATION COMPLETE
Or, for continuous media:
CONTINUO US MOD E
CALIBRATION COMPLETE
The calibration
was successful.
See note below if
another message
was displayed.
10
Exit upon successful
calibration: Back out of
the menu tree by
repeatedly pressing the
key.
If using gap or reflective
media, press and hold
the FEED key. The
printer will begin
advancing media; allow
at least one label gap (or
mark) to advance under
the sensor.
READY
The printer is now
ready to begin
printing.
If this calibration
was not successful,
go to Section 5.0.2.
ã Note: A ‘Warning Low Backing’ message indicates that the calibration was
successful with notched media or media on a transparent liner; see
Section 6.1 for details on this and other possible messages.
To Next Page
Loading...
